Saturday, November 7, 2009

An Outdoor Guide On How To Make Wooden Freshwater Fishing Lures

By James Kitch

One of the most sought after fishing lures is the ones made out of wood. They are durable and can be repainted when they start to show signs of excessive use. Some of the higher quality lures can be quite pricey so many fisherman (or fisherwoman) would like to know how to make wooden freshwater fishing lures.

These fishing lures can be found in just about any department store and can be found on web sites dedicated to fishing and sporting equipment. The prices vary, depending on the brand and size of the lure. There is a less expensive alternative to purchasing a store bought lure. With just a few supplies, a wooden fishing lure can be made in a matter of minutes. The following is one of the easiest ways to create a wooden lure.

1. Cut an aluminum can and flatten it into a thin sheet of material. Be careful when cutting and shaping sheet metal, it can quickly turn into bodily injury.

2. With shears sharp enough for sheet metal, cut spoon shaped pieces from the sheet of aluminum. They should taper on the end and a variety of sizes is suggested. These pieces should resemble a small fish such as a minnow.

3. The next step is to cut a slit in the head of a clothes pin, about a half inch deep. Add some strong adhesive into the cut and insert the aluminum fish into the slit.

4. A hole can be drilled on the bottom side of the lure for placement of the hook. Any hook can be used. Use the same glue to hold them in place.

5. The legs of the peg should then be cut off flush to the head of the clothes pin. A hole can be drilled from one side of the front of the pin to the other. A stick pin with beads on the ends can be glued to create the illusion of eyes

6. Next step is to paint the lure. Bright colors such as orange and red seem to attract more fish that the duller colors.

The freedom of experimentation is just one of the advantages to creating unique wooden freshwater fishing lures that can be used for years to come. Be careful when making this type of lure. Use thick gloves when handling and forming sheet metal.

About the Author: